VLANs and Trunks Packet Tracer 6.1 Activity

VLANs and Trunks – Activity Overview

In this graded Packet Tracer 6.1 activity you will configure two Cisco Catalyst 2960 switches with VLANs and Trunks. The tasks include named VLANs, a trunk between two switches, and a management IP address on each switch using switched virtual interfaces or SVIs. You will also need to configure hostnames on the switches and each PC, with an IP address and subnet mask.

VLANS and Trunks Packet Tracer diagram and physical topology

Instructions

1. Set the PC’s IP addresses based on the host address label and VLAN color code in the topology diagram
2. Assign the switch hostnames based on their labels.
3. Configure the switch VLAN numbers and VLAN names according to the diagram.
4. Configure Interface VLAN88 (SVI) addresses on both switches according to the diagram.
5. Change the switchports as access ports and assign them to VLANs according to the diagram.
6. Configure G0/1 as a Trunk. Allow the listed VLANs only across the trunk and configure the Native VLAN as shown
7. Shutdown the G0/2 interface.

Download

For this graded activity you will need Packet Tracer version 6.1 or higher.

VLANS-Switchports-Trunks-SVIs.zip

IOS CLI Commands for Switch S1

Switch> enable
Switch# configure terminal
Switch(config)# hostname S1
S1(config)# vlan 10
S1(config-vlan)# name students
S1(config-vlan)# vlan 20
S1(config-vlan)# name faculty
S1(config-vlan)# vlan 30
S1(config-vlan)# name administration
S1(config-vlan)# vlan 88
S1(config-vlan)# name management
S1(config-vlan)# vlan 99
S1(config-vlan)# name native
S1(config-vlan)# exit
S1(config)# int range f0/1 – 8
S1(config-if)# switchport mode access
S1(config-if)# switchport access vlan 10
S1(config-if)# int range f0/9 – 16
S1(config-if)# switchport mode access
S1(config-if)# switchport access vlan 20
S1(config-if)# int range f0/17 – 23
S1(config-if)# switchport mode access
S1(config-if)# switchport access vlan 30
S1(config-if)# int f0/24
S1(config-if)# switchport mode access
S1(config-if)# switchport access vlan 88
S1(config-if)# int vlan 88
S1(config-if)# ip address 192.168.88.254 255.255.255.0
S1(config-if)# int g0/1
S1(config-if)# switchport mode trunk
S1(config-if)# switchport trunk allowed vlan 10,20,30,88,99
S1(config-if)# switchport trunk native vlan 99
S1(config-if)# int g0/2
S1(config-if)# shut

Author: Dan

Dan teaches computer networking and security classes at Central Oregon Community College.

Leave a Reply

Your email address will not be published. Required fields are marked *