Packet Tracer 6 Activity – RIPng and IPv6

RIPng PTactivity

Overview

The goal in this activity is to configure an IPv6 network with the RIPng routing protocol. In addition to configuring RIPng on the routers, you will need to configure all of the devices in the network with the correct IPv6 addressing. The goal is to configure the routers and PCs with the following information:
• Enable IPv6 routing on all routers,
• On all routers, configure link-local and global unicast IPv6 addresses with network prefix lengths (see the network diagram),
• On routers R1, R2, and R3 configure the RIPng IPv6 routing protocol (use the name: RIP1 in all caps as the routing process name),
• On router R1, configure a default route towards the ISP router, and use RIPng to distribute that route to routers R2 and R3,
• On router ISP, configure a summary route to reach all of the subnets on R1, R2, and R3,
• On the PCs configure static IPv6 addresses with network prefix lengths, and gateway addresses (see the network diagram),
• Configure hostnames on all routers and save the running configuration to the startup-configuration file

The scoring is based on the total number of items correctly configured. Remember that when entering configurations the system is case sensitive. When you are finished, you should be able to communicate across the network (e.g. successfully ping PCB from PCA)

RIPng PTactivity

Download

RIPng.zip

Note: You will need Packet Tracer version 6.0.1 to open this activity

Spoiler Alert – read below if you are stuck and need help with the commands

IOS Command List

router>enable
router#configure terminal
router(config)#hostname R1
R1(config)#ipv6 unicast-routing
R1(config)#interface g0/0
R1(config-if)#ipv6 address FE80::1 link-local
R1(config-if)#ipv6 address 2001:DB8:DA:1::1/64
R1(config-if)#ipv6 rip RIP1 enable
R1(config-if)#no shut
R1(config-if)#interface s0/0/0
R1(config-if)#ipv6 address FE80::1 link-local
R1(config-if)#ipv6 address 2001:DB8:DA:2::1/64
R1(config-if)#ipv6 rip RIP1 enable
R1(config-if)#ipv6 rip RIP1 default-information originate
R1(config-if)#clock rate 128000
R1(config-if)#no shut
R1(config-if)#interface s0/0/1
R1(config-if)#ipv6 address FE80::1 link-local
R1(config-if)#ipv6 address 2001:DB8:CD1:C::2/64
R1(config-if)#no shut
R1(config-if)#exit
R1(config)#ipv6 route ::/0 s0/0/1
R1(config)#exit
R1#copy running-config startup-config
R1#show running-config
R1#show ipv6 route
R1#show ipv6 int brief

Author: Dan

Dan teaches computer networking and security classes at Central Oregon Community College.

Leave a Reply

Your email address will not be published. Required fields are marked *